Vauxhall Firenza Droopsnoot s
The Firenza was offered by Vauxhall from May 1971 until 1975. It was a development of the Viva, but had a distinctive coupé body style (fastback) and only two doors.

The initial Firenza was available in a base model 1159 cc overhead valve and two models with overhead camshaft, in 1598 cc and 1975 cc variants. The latter was the same engine as used in the earlier Viva GT.
Some six months after launch, in December 1971, performance was boosted when the engine capacities were enlarged to 1256 cc, 1798 cc and 2279 cc respectively. All models had a front-mounted four-cylinder engine driving the rear wheels. Suspension was double wishbone and coilsprings at the front, and a live rear axle with trailing arms and coils at the rear. The SL model in each engine size carried the highest level of trim.

The model changes in early 1972 included the introduction of a top-of-the-line 2300 Sport SL model (introduced at the Geneva Motor Show), using the 2279 cc engine. The 2300 Sport SL was the only version to feature the seven dial dash (speedometer, clock, rev counter, fuel, oil pressure, water temp, & battery charge). The engine was an inclined four-cylinder with single overhead camshaft and twin Stromberg carburettors, producing 122 bhp (91 kW; 124 PS). The oversquare straight four engine was renowned for its big torque curve, making the car very flexible and easy to drive. The interior was equipped with bucket seats, front and back, to carry four persons. The centre console with heater controls and warning lights was quite distinctive and luxurious for the time.

The 2300 Sport SL was raced in by the Dealer Team Vauxhall, following their successes with the Viva GT. In Castrol colours, these cars enjoyed many successes.

In 1973, Vauxhall acknowledged that their rather dull model range needed a makeover, and developed a radical version of the Firenza, known officially as the High Performance (HP) Firenza, but known colloquially as the “droopsnoot” after its dramatically styled aerodynamic nose. The nose was moulded from GRP, and featured two pairs of Cibié headlamps behind toughened glass covers. The overall look was somewhat reminiscent of the Renault Alpine A310, and used the same headlamp units.
Several prototypes of the HP Firenza were considered with different types of front end treatment, requiring different degrees of change from the standard production front end, including cars known as Black Knight and Daytona, the latter for its resemblance to the Ferrari Daytona, a favourite of Wayne Cherry.

At that time, the original flat-fronted Firenza model was re-badged as the Magnum coupé, and the name Firenza was used exclusively for the HP version. This car was an exciting styling departure for Vauxhall, and certainly created something of a buzz.
The engine was the 2.3-litre variant of the OHC Slant Four engine, uprated to a very torquey 131 bhp (98 kW) using a variety of parts developed by Blydenstein Racing.
It had twin 175 Stromberg carburettors, high-lift camshaft and free-flow tubular exhaust manifold.
The car was restyled on the David Jones original by American designer Wayne Cherry and the result was an exceptionally low drag coefficient for its time.

Suspension was uprated and lowered, brakes uprated, and a 5-speed ZF dog leg gearbox was installed, a much stronger unit than fitted to the standard model (though rather noisy).
Another unusual and unique feature of the car was the alloy Avon Safety Wheels, which were designed to retain the tyre safely in the event of a puncture. This was the first car to use these wheels in production.
All production cars were painted in the same colour – Silver Starfire, and featured a largely black interior with silver-grey cloth seats. An unusual interior feature of dubious utility was the passenger grab handle on the dash in place of the standard glovebox.

The car was a design triumph for Vauxhall, but a marketing failure. The car was launched to much publicity in a special one-off race at Thruxton circuit in Hampshire, with top drivers of the day taking part including Gerry Marshall and Barry “Whizzo” Williams, who won the race. However, the fuel crisis of the time meant that suddenly it became very hard to sell gas-guzzling cars like this, and coupled with some production line difficulties in actually building the car meant that sales and delivery were slow, and eventually just 204 examples were built, far short of the 30,000 projected. This very low volume was obviously a disaster for Vauxhall, but ironically it has led to the car becoming a very collectible classic, thus ensuring its survival.
Some of the much more common production cars produced alongside it can be now harder to find. Celebrity owners of droopsnoot Firenzas are footballer Luther Blissett and formerly sports commentator Stuart Hall.

The Firenza was also very successful in saloon car racing in the 1970s, especially in its Old Nail and Baby Bertha versions, piloted to great effect by Gerry Marshall.

Despite the low production run, the aerodynamic qualities and styling of the “droopsnoot” were incorporated, with improved production, into most of Vauxhall’s remaining 1970s new models like the Chevette, Cavalier and Carlton.
The Firenza can be seen as a styling prototype for these models. Its influence can be judged from the fact that Ford adopted a very similar look for its Mk II RS2000 Escort and the 1982 Ford Sierra, which in turn were widely copied throughout the 1980s by others. For this reason, the HPF looks far less dated than many of its contemporaries.

And on to the numbers; Top Speed was 120 mph (190 km/h) with a 0 to 60 of 8 seconds.

The Droopsnoot Firenza’s front end strongly influenced the design of the Arcadipane “Concorde” body kit marketed for the Ford Falcon XB, famously portrayed by the Pursuit Special in the Mad Max films. And the Droopsnoot Firenza also appeared in the computer game “The Getaway: Black Monday”.

Droopsnoot launch race at Thruxton video here.

Droopsnoot Club.

Vauxhall owners club.

More Great Cars featured here.

Click images to enlarge,